Summary:...
1. Under certain circumstances, it is not allowed to use a hammer to knock the pulley, coupling, pinion or sprocket into the output shaft, which will damage the bearing and shaft.
2. The reducer can only be installed on a flat, shock-absorbing, torsion-resistant support structure.
B, the preparations before the operation of the reduction gearbox
1. The operating temperature of the reduction gear box is 0-40 ℃.
2. Before use, the blockage at the position should be replaced with an exhaust screw plug, and the gas in the body will be discharged when the gearbox is running.
3. Check whether the matching size of the hole (or shaft) connected with the reducer meets the requirements. The tolerance of the hole should be H7 (the tolerance of the shaft is H6).
4. The installation shaft of the reduction gearbox should be cleaned before use. And check the installation shaft for bruises and dirt, and if so, clean them all up.
C. The use and maintenance of the reduction gearbox
1. It is strictly forbidden to use the reduction gearbox beyond the rated load.
2. After the reduction gearbox is installed, check whether it is flexible. For formal use, no-load test must be carried out, and in the case of normal operation, it is gradually loaded and operated.
3. Check whether the oil level of the reduction gear box is normal before use and during work. If the oil level is abnormal, the meshing between the gears and the gears will be abnormal and affect the life of the gear box.
EN
